2165 Turntable

Key Features

• Fiber optic control lines eliminate RF noise
• Ultra-low profile, 5cm
• Variable speed motor

Description

The 2165 LoPro™ turntable can be used with the popular ETS-Lindgren Model 2090 Multi-Device Positioning Controller or separate Hand Control Unit.

With a top almost flush to the ground plane, excavating a pit to bury a power train assembly is not necessary. LoPro™ can be used at indoor or outdoor (if the turntable is properly protected from rain, moisture, etc.) sites where traditional turntables are impractical or impossible to install. In chambers, antenna scan height is maximized because space robbing sub floors are not required. The LoPro's minimal height and ABS/PVC construction is virtually RF invisible, so site attenuation characteristics are virtually unchanged. The optional drive shaft can be used for increased RF isolation of the shielded motor if desired.

Signal I/O between the motor base and optional ETS-Lindgren Model 2090 Multi-Device Positioning Controller is fiber optic, eliminating a potential source of RF interference. The turntable includes 10 meter of fiber optic cable. Additional lengths of cable are available. The LoPro™ is portable for maximum utility. The unit can be easily disassembled within a few minutes. For more permanent installations, mounting holes for anchor bolts are provided on the base. The unit's toothed-belt drive ensures non-slip rotation for greater positioning accuracy.