6502 Active Shielded Loop Antenna - ETS-Lindgren
Product Image

Key Features

  • Frequency Range: 9 kHz - 30 MHz
  • Two Year Warranty
  • Individually Calibrated per ANSI C63.5
  • Remote Monitor Option
  • Saturation Indicator
  • Download PDF Datasheet
  • The preamplifier helps this loop antenna produce good sensitivity and almost constant antenna factors when testing for EMC applications. A preamplifier is built into the base and provides a 50-ohm output.
    The saturation indicator is activated when an incoming signal exceeds the 5 V/m saturation limit of the internal preamplifier. Power for the preamplifier is supplied by rechargeable sealed batteries. Front panel controls and indicators for the preamplifier include a power switch, power-on indicator, saturation indicator, and a receptacle for a battery charger. A switch selectable battery charger for 115 VAC or 230 VAC 50/60 Hz operation is included.
    Every loop antenna is individually calibrated in accordance with ANSI , C63.5 using NIST traceable equipment. By knowing the actual antenna factors and performance characteristics of an antenna instead of typical data, you can more accurately measure field strength in your tests.

    View the 6502 Active Shielded Loop Antenna technical specifications below

    Physical Specifications

    Height 67.3 cm (26.50 inches)
    Length 12 cm (4.72 inches)
    Weight 2 kg ( 4.41 lb )
    Width 19 cm (7.48 inches)

    Electrical Specifications

    Frequency Minimum 9 kHz
    Frequency Maximum 30 MHz
    1 dB Comp. Point 5 V/m
    Connectors BNC (f)
    Dynamic Range 125 dB @ 1 MHz
    85dB @ 10 kHz
    Impedance (Nominal) 50
    Pattern Type omnidirectional
    Polarization linear
    Power Required
    110/230VAC 50/60Hz
    (Switch Selectable Battery Charger)
    Sensitivity (Typical)-1 dB(A/m) @ 10 kHz
    -42 dB(A/m) @ 1 MHz

    Product Options

    Custom cases are available upon request.

    Product Configuration

    Antenna/loop assembly
    Battery Charger Mounting Bracket drilled accepts an ETS-Lindgren or other tripod mount with standard 1/4 in x 20 threads.